Note: See D-Link DIR-600 for D-Link DIR-600 Rev.A1 (different. D-Link Dir-300 B5: D-Link DIR-600 B5?, ZyXEL Keenetic Start? There is another revision of the DIR-600 router available on the market.
![]() From DD-WRT Wiki
Jump to: navigation, search
This page also applies to the DLink DIR-300 Rev.B
It is important to note, DIR-300 Rev A1 and Rev B1 are completely different hardware, different SoC, different procedure. So, if you have the old DIR-300 Rev A router, its install procedure is already well documented elsewhere. Rev B1 is based on Ralink RT3050 SoC and from all accounts, including Dlink's FCC test report, the PCBA is exactly the same as in the DIR-600.
You can tell which Rev of the hardware this router is from the box (it will say 'H/W Ver: B1 F/W Ver 2.00' for example on the bottom of the box, underneath the barcode. 'H/W Ver.: B5 F/W Ver.: 2.10' is not supported and does not work. ). A similar sticker with the hardware version and firmware version is also stuck on the bottom of the router itself. This means it's quick and easy to check the hardware revision before buying or borrowing it.
The factory default IP for this router is 192.168.0.1, user is 'admin', password is blank.
[edit]Pros of this hardware
[edit]Cons of this hardware
[edit]MainBoard[edit]Out-of-the-box factory firmware upgrade
To install dd-wrt on either a D-Link DIR-300 Revision B1 or a D-Link DIR-600 Revision B1, you need to flash it directly from the router's web admin page (yes, that is correct... from D-Link's standard web interface). These are the steps to follow:
[edit]Alternate Install Method using Emergency Room Web Interface
![]() [edit]How to upgrade with new DD-WRT firmware
[edit]How to reset the Router to initial DD-WRT configuration
If you forget the username or password, or if the configuration becomes really messed up, you can always clear all the non-volitile parameters by doing a 'factory reset'. To do this, with the router already fully booted, press and hold the reset button for 5~6 seconds and release. The router will boot back up and answer to 192.168.1.1 just as if it had just been flashed with DD-WRT.
[edit]How to restore to factory firmware[edit]Method 1
To get back your D-Link DIR 600 router to its original D-Link firmware:
[edit]Method 2
You can download stock firmware with wget, and flash with the mtd command.
Example:
1. Make sure that your router is connected to the Internet.2. Login to your router with telnet or ssh.3. Type the following command to download stock firmware V2.04 for DIR-300 B1.Code:wget -O /var/firmware http://nokiafon.pl/ruter/DIR300B_FW204WWB01.bin
4. Type the following command to flash your router with the downloaded stock firmware.Code:mtd write /var/firmware linux
5. If there is no problem during the operation above, reboot your router.
Retrieved from 'http://wiki.dd-wrt.com/wiki/index.php/D-Link_DIR-600vB_/_300vB'
For a list of all currently documented Ralink chipsets with specifications, see Ralink.
Wireless N150 Router
'8WRGN49..1A1G' is silkscreened on the board in the FCC photos.
Retrieved from 'http://en.techinfodepot.shoutwiki.com/w/index.php?title=D-Link_DIR-600_rev_B5&oldid=50699'
![]() Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |